FX – FJ VZ V6
INDEPENDENT FRONT END.
V6 Conversions have developed a conversion kit that allows the instillation of the Holden Commodore VZ V6 to the above vehicles. The kit is designed to replace the original grey motor & gearbox. The kit is designed to take the T700 or T5 gearbox. There is some cutting and welding required in the gearbox tunnel area. The instillation is carried out with the use of the New Front End.
We use a remanufactured rear mounted rack & pinion from a VB-VK Commodore which comes in our kit complete from tie rod end to tie rod end with all mounting brackets & bolts and instructions. With this steering kit you can use HR disc brakes or HQ-WB stub axles and brakes or we can offer you a stub axle that will accept VN-VP brake assembly.
The steering column used is up to the individual, in our instruction sheet we give you the measurements to convert the column or we have an exchange unit available.
We have covered part of the braking in the steering, we have found the best combination is to use the brake pedal assembly from the VN-VP power booster and master cylinder. In some cases the pedals will need to be re-bent to clear the steering column.
FUEL & EXHAUST.
In our conversion kit we supply a set of extractors to clear the inner guards and firewall. We recommend that you run the catalytic converter and a 2 1/2” system and a full flow turbo muffler.
In our conversion kit we supply you with a gearbox cross member and gearbox tunnel, the gearbox cross member is part bolt in part weld in, with a reinforcing beam that goes between the gearbox tunnel and the gearbox. This beam is welded into the original cross bracing of the tunnel. The gearbox tunnel is then fully welded in, when completed you can use the floor mat or carpet that suits an EK automatic floor.
The wiring kit we have available covers from VN-VY, it comes in 2 parts, the under bonnet loom with all relays and fuses and the under dash loom which incorporates an engine trouble light. This wiring kit plugs into the original V6 engine and gearbox loom leaving only 6 wires to be tapped into your vehicles original loom which are – alternator light, oil light, temp light, ignition, starter & tacho.
Our speedo kit comes in 2 forms, an inline speed sensor & cable to suit VN-VP or an electronic speedo for VR-VY auto instillation.
It is best to use the original radiator, it is advisable to have the radiator serviced, and run an overflow tank and radiator cap. In all these conversions we run a 16″ thermo fan which is mounted in front of the radiator and plugs into our wiring loom.
An Engineers Report is required after the conversion has been completed. Contact your local RTA Office for a list of Engineers.
Requirements for Engineering are that seat belts must be fitted and 2 speed wipers plus a heater demister
You will need to obtain the following components –
* The Commodore V6 engine complete with the main engine wiring harness, the ECM. Other accessories such as the map sensor, purge canister, air cleaner & ducting, engine pipes & catalytic converter, external fuel pump & damper,
gearbox & gearbox wiring harness and gearshift assembly.
* New Front End
* wiring kit with BCM
* speedo kit
* header kit